This the manual and user guide for Whirlpool WTW5057LW washing machine. View for troubleshooting guide.
Whirlpool 2 in 1 Removable Agitator User Manual
How To Remove Whirlpool Agitator
This is how to remove the Whirlpool WTW5057LW Agitator floor from the washing machine;
- 1. Unplug washer from power source.
- 2. Open the washer lid.
- 3. Grab the agitator floor firmly and lift it straight up.
- 4. The agitator floor should come off easily.
Note – If there is any object (pillow case e.t.c) stuck underneath the agitator floor, you’d have to remove it carefully.
Where To Put Fabric Softener
Some models of the Whirlpool Washing Machine don’t have a fabric softener dispenser. If this is the case, you can manually add the fabric softener during the rinse cycle. Pour directly into the water, rather than on top of the clothes, to prevent the possibility of stains.
How To Fix Whirlpool WTW5057LW washing machine Not Filling or Spinning;
The fault could be the water inlet valve or the drain system. Here’s how to fix –
- 1. Check the water supply valves are fully open and that there is adequate water pressure.
- 2. Inspect the water inlet valve: it could be clogged or malfunctioning. If necessary, replace the water inlet valve.
- 3. Check the drain system and ensure that the hose is properly connected and not kinked or clogged. You should also verify that the drain hose is inserted into the standpipe or laundry tub at the correct height to prevent siphoning. Note – If the drain system is not functioning properly, it can cause the machine to shut off.
- 4. Test the lid switch: Make sure the lid is securely closed and that the lid switch is functioning correctly. Note – The lid switch is a safety feature that prevents the washer from spinning when the lid is open.
How Long Does Whirlpool 2 in 1 Removable Agitator Take To Wash on Normal?
Using the Whirlpool, a normal wash cycle usually takes between 50 minutes to an hour to complete. However, this time is dependent on the load size, the cycles or options you choose.
How to reset whirlpool 2 in 1 removable agitator washer
To manually reset the Whirlpool 2 in 1 removable agitator washer (top-load model), here are steps to take;
- Turn the cycle selector knob to the “Normal” position.
- Turn the knob counterclockwise for one click, clockwise for three clicks, counterclockwise for one click, and finally clockwise for one click.
- Press the start button to complete the reset.
